This just in and in our best impersonation of Professor Farnsworth’s voice, ”Good news everyone!”
This light controller allows to light up X-Wing engines, the droid eye, and the cockpit control lights. The controller board comes pre-assembled, ready to use. The small size allows installing the controller inside the hull of any size X-Wing down to 1/48 scale. Set any color and the pulsing speed for the engines with a simple turn of potentiometers as well as adjust the colors of the LEDs for the cockpit light effects.
Small Picoblade connectors and thin 26AWG wire allow to route the cables through tight spaces without the need of de-soldering the LEDs. The controller has a built-in protection from reversed polarity. The supplied voltage can range from 6V up to 16V. The controller can be used with any other model as well.
-
- Truly small size 2.25″ X 0.6″ X 0.25″ (55mm X 16mm X 7mm)
- Change the color and the pulsing speed of the engines to any value
- Adjust the colors of the LEDs for the cockpit light effects
- Small Picoblade connectors and thin 26AWG silicone wire to fit through narrow spaces
- Protection from reversed polarity
- A wide range of acceptable voltages 6-16V
- Mounting Holes
- Clear heat sinks for dramatic running engine light effect
- X-Wing Light Controller for 1/29 Scale, 1/24 Studio Scale, and 1/18 Scale
- Retails for $85.00 USD
The controller set comes with the following components:
- The controller
- Four 5mm or 8mm Engine light LEDs
- Four 5mm LEDs for the droid eye and cockpit light effects
- Power cable
- Clear heatsinks
Supplied with the controller are clear engine inserts (heat sinks). They allow for more light to go through the engines creating a dramatic light effect of working engines. The clear heat sinks are available in 1/29, 1/24 and 1/18 scale.
Assembled engines with installed heat sinks and LEDs
